Power Handling Co. Ltd

Created on 2012-03-01

Jungheinrich launches a new narrow aisle truck on the market in May 2012. This is an order picker / 3-was stacker type EKX 410 with electric motor – in short: a Kombi truck. The truck, used exclusively in narrow aisles, can be used for stacking and retrieving pallets or box pallets as well as for picking individual articles.

Technology upgrade: Warehouse Navigation now also available for EKX 410

With the market launch of the EKX 410, it is now possible for the operator of the “little” Kombi to use Jungheinrich Warehouse Navigation to its full extent on this truck. “The focal point during the redevelopment of this truck generation was put on a technology upgrade for transponder technology and warehouse navigation in narrow aisles“, says Riedmaier. The same as his “big brother”, the EKX 513-515 since 2008, the truck can now communicate with customer-specific warehouse administration systems. Here, the information of the warehouse administration system goes into the control of the narrow aisle truck via the Logistics Interface.

The truck receives stacking, retrieval or order picking orders from the warehouse administration system and the operator only confirms these. The drive approaches the aisle where the goods are stored. The semi-automatic approach of the storage position in the aisle by the truck starts subsequently. “The required racking position is approached by the shortest route, at optimum speed and lowest use of energy after being released by the operator”, explains Sebastian Riedmaier. “Experience over the past years has shown that throughput efficiency can increase by up to 25 percent when warehouse navigation is utilised“. LogiMAT 2012 visitors can “experience“ the EKX 410 with warehouse navigation themselves on a special test run.

New Kombi from Jungheinrich: Open to future requirements

The modular platform concept from Jungheinrich with many configuration possibilities has proved its worth for years. It endows the Kombi truck with very good adaptability to current and future requirements. An intelligent truck management with TÜV certified control and CAN-Bus system provides a number of safety characteristics und keeps the truck open to future requirements.

The EKX 410 is a high rack stacker with up to 1,000 kilogram capacity. The truck now achieves lift heights of over nine metres and stands for high throughput efficiency in a narrow aisle warehouse due to 3-phase AC technology. “Dependent on the application, the truck can be equipped with different performance packages and thus achieves top values in the 48 Volt class“.